PLEASE SELECT THE DESTINATION COUNTRY AND LANGUAGE :
|카드 결제, 적립금|
할인가가 적용된 최종 결제예정금액은 주문 시 확인할 수 있습니다.
① Fold the body along the fold line.
② Insert the +snap button into the top and bottom grooves of the body.
Insert the -snap button into the inner hole.
*Body 2 has a groove at the bottom.
③ Fix body 2 and 3 to body 1. Please check the body number as shown in the picture.
*Cut the short rods to fit body 2 and 3 sizes.
④ Insert a short rod(102mm) into the holes in body 2 and body 3 and fix both sides with rubber rings.
*Insert the holder on both sides of the 244mm rod and only one side on the 330mm rod.
⑤ Rails are made by connecting the middle bar to the center of the short bar.
The long rod is inserted at the bottom and the part without the holder is inserted into the groove under the body 2.
*Body plate 2 -> Put the holder one more time in the middle at 1 and 3.
Body plate 3 ->Insert one more holder in the middle of 2.
Open it properly, except where it is held by the holder to allow the ball to flow.
⑥ Fold the paper rails and fasten them with snap buttons.
Secure the wings by inserting them into the grooves on both sides of the paper rail.
⑦ Secure the paper rail by inserting it into the grooves 2 and 3 of the body.