PLEASE SELECT THE DESTINATION COUNTRY AND LANGUAGE :
|카드 결제, 적립금|
할인가가 적용된 최종 결제예정금액은 주문 시 확인할 수 있습니다.
Mechanical movements force the ball of another device to actuate
Corrugated cardboard, Plastic, Rubber
Corrugated Slide (Body, Switch, Swivel), Snap Button, Black / Red Rubber Ring, Transparent rod, White Rod
When the ball rolls with the Goldberg connector and touches the bottom of the push switch, mechanical movement pushes the ball out of the other device.
It can be used between C-2 and C-4 and can be used depending on the situation in other devices.
1 Step. Make a body
① Fold the body along the fold line.
② Assemble by inserting three body hooks.
③ Fold the swivel stand along the fold line.
④ Fix the swivel stand into the groove inside the body.
2 Step. Make a swivel
① Fold the two swivel and one fixing plate along the fold line.
② Insert the fixing plate between the swivel plates to fix it.
③ Pass the transparent rod (long) through the middle groove of the swivel and fix it with black rubber ring on both sides.
3&4 Step. Make 1,2-stage switch & connect 1-stage switch and swivel
① Overlap two switches and secure them with snap buttons as shown in the figure.(3 snap buttons. Check the fixed position)
② Pass the transparent rod (short) through the middle groove of the 1st stage switch and fix both sides with black rubber ring.
③ Pass the white rod (short) through the lower groove of the 1st stage switch and insert it with red rubber ring at both ends.
① Put the white rod of the 1st switch into the upper groove of the swivel and fix it with both sides with red rubber ring.
*Adjust the red rubber ring to fit the gap between the swivels.
5&6 Step. Connect the body and the first switch&Make a two-stage switch
① Insert the 1st stage switch into the inside of the body so that the 1st stage switch comes out of the groove on the top of the body.
*Be careful not to insert the 1st stage switch into the swivel stand inside the body.
② Align the transparent rod of the swivel with the two grooves of the body so that the white rod can pass through the transparent rod.
③ After passing, fix the white rod with red rubber ring on both sides.
④ Use a white middle rod at the top of the body and a white long rod at the bottom.
*Check again that the white rod has passed through the transparent rod.
① Fold the push button in half and insert it into the groove suitable for the height.
7&8 Step. Complete and operate the push switch
① Connect the grooves of the 1st switch and 2st switch to each other.
*Fix it firmly so that it does not shake.
① Place the switch vertically. (The ball hits the swivel at the bottom of the body.)
② As the 1-stage switch moves, the push button of the 2- stage switch moves forward.
9 Step. Connect your Goldberg device
① Put the push switch in front of the waterfall rail.
② Roll the ball and observe the movement of the push switch.
*Adjust the position so that the push button of the push switch contacts the bead when it is moved.